The disks to stoning Lapmaster manual are intended for research and development or for production of small quantities.

These disks are made of fused alloys of low porosity to ensure high material removal, low wear of the disks and good surface finish of the parts cut.

Polishing discs, are recommended for soft materials like carbon and plastic. These discs have a molten base where deposited a special alloy to ensure minimum wear.

When used with appropriate polishing powders, finishes are obtained 1 to 2 micro inches without difficulty.

Lapmaster portable device for polishing, enables the obtaining of surfaces that reflect light ideal for inspection with plain lenses and monochromatic light.

With a simple fastening system, an area of 12 x 12 sandpaper is rìgidamente inches set in order to facilitate the operation of polishing.

Flat lenses are manufactured in diameters ranging from 25 mm to 300 mm. These lenses are made of quartz, known for your material characteristic of low expansion coefficient and high resistance to abrasion.

The calibrators flatness Lapmaster enable fast verificaçào lapidary discs, indicating the value of flatness error and if the surface is concave or convex. A chart set in calibrator, allows the transformation of the value found for bands of light.

The monochromatic light source Lapmaster, is used to measure flatness of up 1 band of light, approximately 1/4 Micron, When used in conjunction with flat lenses described above.

These lamps use helium gas to produce light of wavelength known, due to a phenomenon of interference of light produces streaks (bands) assessing the flatness.

There is a wide variety of discs for rough or Polish from the most common materials until the rarest. Like this, cast iron discs are used in most applications. Ceramic discs, are used in ceramic and other hard materials, and so on. Consult us about your application.

The rings Lapmaster conditioners, are constructed in different materials according to the above discs. Are used to keep the pieces on the cutting discs and to keep the flatness of same.

Lapmaster adhesives are manufactured in many sizes and materials for different applications. As the name implies, one side has glue that allows your on lapping disks making it possible for glass polishing, semi conductor materials, etc., in a conventional lapidadora.

The system to administer the application of diamond abrasives are designed to control costs while maintaining the application of diamond with accuracy of 0,2 g. This is made possible by the microprocessor-based electronic circuits. With this device, You can get excellent control of surface roughness.